Legal disclaimer

Legal validity of this disclaimer

This disclaimer is an integral part of the internet publication from which you were referred. If any parts or individual formulations of this statement should fail to conform to the valid legal situation, or be no longer or not fully in conformity therewith, this shall not affect the content or validity of the remaining parts.


For information concerning data protection, please refer to our privacy policy.

Contents of the website

XPLM accepts no responsibility for the topicality, correctness, completeness or quality of the information provided. Liability claims for damage caused by the use of any information provided, including any kind of information, which is incomplete or incorrect, will therefore be rejected. All offers are not binding and without obligation. XPLM reserves the right to append, modify or delete parts of the pages or the complete content including all offers and information without prior notice.

Copyrights and trademarks

XPLM endeavours to respect the copyright of the featured graphics, sound recordings, video sequences, and texts used in all publications, or to use their own graphics, sound recordings, video sequences and texts or to make use of licence-free graphics, sound recordings, videos and texts. All the trademarks named in the Internet offer and, where applicable, those protected by third persons, are subject without restriction to the legal provisions of the applicable trademark law and the ownership rights of the respective registered owner. It should not be assumed that the mention of trademarks implies that such trademarks are not protected by the rights of third parties. The copyright for any published items produced by the XPLM shall remain solely with XPLM. No graphics, audio recordings, video sequences or texts contained herein may be used, reproduced or redistributed in any manner without the express written permission of  XPLM. Solid Edge, Unigraphics NX, I-deas NX Series are trademarks of UGS, Pro/INTRALINK, Pro/ENGINEER Wildfire are trademarks of PTC, mySAP/PLM is a trademark of SAP, SolidWorks and CATIA are trademarks of Dassault Systèmes.

Referrals and links

XPLM accepts no responsibility for any contents linked or referred to from their pages – unless XPLM has full knowledge of illegal contents and it would be technically possible and reasonable to prevent visitors to its site from accessing such pages. XPLM explicitly declares that at the time of setting links no illegal contents were recognizable on the linked pages. XPLM has no influence on the current and future design and contents of the linked sites. XPLM expressly distances itself from all content on all linked sites that may have been changed since the links were placed. This declaration applies for all the links and references set within the scope of XPLM′s own Internet offer and also for entries by third persons in guest books, discussion forums, link listings, mailing lists and in other forms of databases, the contents of which can be accessed and written to externally. The provider of the linked page alone shall be liable for illegal, faulty or incomplete content, and in particular for losses resulting from the use or non-use of information provided in this way, and not XPLM who simply make reference to the respective publication by means of the links.